| Subject | Text |
| technics se-hd81,lost sound? | hi,not quite sure if there is no sound?---but okay on headphones. first check wiring is okay to spe |
| [quote:3c9c28b759="fongs"]Hi,
1. Does the set power up?
2. Speakers - are they connected prope |
|
|
| Audi A6 1995 (cassette radio) | Is there a replacement radio for my car w/o having to cut wires and change the speaker system ?
R |
| Re: Onkyo TX-SV535 Amp / Remote Speakers NOT Working | [quote:0d4d64b6e9="kayecross"]I can not get the remote speaker button to work on my amp. I have inst |
| 200/300W power amplified speakers | Hi all,
I need help to find out a good complete project for internal amplifier system for speaker f |
| I have same problem with my tx-ds494. no its not my speakers. or inputs, definately output in "A" sp |
| Toshiba 3787DB - Very low Base / Woofer output | Getting a very low output on the sub woofer, with the sub and the base turned all the way up you can |
| Sony Sa-va 700 | Hi! I am having problems with my system. The right side rear speaker keep turning on and off. I chec |
| hardon karmon 7 channel amplifier, 1 channel very low ?? | hello im curretnly working on a hardon karmon avr 507 7 channel amplifier,
it all works ok apart |
| PHILLIPS TV SPEAKERS | HELLO, To begin with the addition of speakers to a unit has to involve the understanding of the tot |
| Taking apart my Philips DECT 2111S/11 | Hi,
I am trying to take apart my Philips DECT 211 phone, because the speaker has managed to come |
| Sony Amp - The woes continue | Andreas,
Try removing every input and output and see what happens, then add them back one by one |
| str-de945 problem | Is the action (or lack thereof) intermittant? If so, it is likely a bad solder joint. The IR sensors |
| SONY STR KSL5 Protect Fault | I have a SONY STR KSL5 home cinema system which after about 5 mins shuts off with the word "PROTECT" |
| Here's the parts that I used:
[url=R509 100K Ohm 1W resistor[/url] - got an set on Amazon. I prob |
| yeah! tv still working but, always need to push the reset button in front. otherwise no signal with |
| repairing an old sansui amplifier | hello every one ,
new member here and also newby in the electronic repair
i have an old sansui |
|
|
| Dead Black Diamond BD28WS | Hello to everyone this is my first post here. I have a BD28WS Black Diamond TV. The fault is when I |
| Looking for Pioneer VSX-D307 Receiver Service Manual | I'm looking for a service manual (or at least a schematic) for my Pioneer VSX-D307 Receiver.
Anyo |
| voltage for relay | hi,i have a problem on my yamaha rx-v392 model...i need to know what is the voltage of the relay in |
| Re: Onkyo TX-SV535 Amp / Remote Speakers NOT Working | [quote:586d3411be="kayecross"]I can not get the remote speaker button to work on my amp. I have inst |
| Hi again,
By bypassing the main speaker relay everything works great. Does anyone know if this mi |
| avr 130 one of the surround outputs is very very low | got a harman kardon avr 130 one of the surround outputs is very very low
when i connected speaker t |
| Re: Do this test | Forgot to mention: Keep CD player's volume quite low to keep from exceeding input level rating of yo |
| Protect mode occurs when an overcurrent situation is detected by the power supply in the amplifier. |
| Headphone circuit for TV needed. | Hello all. I hope this is the right place for my question. Ok, I have a infrared wireless headphon |
| Blowing speaker protection fuse suggests failure of the power amplifier output transistors. If a DVM |
| Hi,
Few things u can check:
1. Does the set power up?
2. Speakers - are they connected prop |
| Siemens Gigaset 4010 Comfort problem | Can make call but can't disconnect (end it.) If I call someone and try to end call only sound is tur |
| I agree with Miguel. if your mixer has PAN controls just turn all of them to the same end so your ch |